Serving Seattle to Mount Vernon — free on-site estimates
Fascia & soffit repair · Edmonds, WA

Fascia & Soffit Repair in Edmonds, WA

Rotted fascia, soffits and rafter tails replaced, with drip edge so the roof edge stays dry. When gutters overflow or the roof has no drip edge, the roof edge gets soaked every storm and slowly rots. We replace damaged fascia, soffits and rafter tails, add drip edge and venting, and leave a solid edge ready for your gutters. We serve homeowners across Edmonds and nearby Lynnwood and Mountlake Terrace.

Licensed, bonded & insured · 24-Month Workmanship Warranty · Free on-site estimate
Before: Rotted siding corner opened upBefore
After: Corner rebuilt, sided and paintedAfter

Corner rebuilt, sided and painted

Edmonds homes

Why fascia and soffit repair comes up so often in Edmonds

Fascia and soffit rot is common on Edmonds homes under mature trees, especially in Perrinville, Firdale and the wooded streets east of downtown. Needles and leaves clog gutters, overflow runs behind them, and the fascia and rafter tails soak through. On view homes facing the water, wind pushes rain up under roof edges that lack drip edge. Decayed fascia boards, sub-fascia and soffit panels come off, damaged rafter tails get spliced or sistered, and we add drip edge and soffit venting where it was missing, and coordinate gutters and guards so the roof edge drains the way it should.

Edmonds began as a waterfront mill town, and that history still shows in the Bowl, where small early-1900s cottages and bungalows sit among mid-century homes and newer infill. The hillsides rising from downtown through Seaview and Westgate filled in from the 1950s through the 70s with view-oriented ramblers, split-levels and daylight-basement houses, often sided in cedar or plywood and fronted by broad west-facing decks. Perrinville, Firdale and the streets around Five Corners added more ramblers and two-story homes, some with T1-11 or hardboard. Many Edmonds houses have been remodeled more than once, so original cedar beside newer fiber cement is a common sight.

Edmonds faces Puget Sound and the Olympics head-on, and most of the city slopes down toward the water. West walls, decks and windows on view homes absorb the full force of winter storms traveling up the Sound, along with salt carried in the spray. Higher neighborhoods to the east are less exposed but still endure months of rain and slow drying. Ravines along Perrinville Creek and Shell Creek hold shade and moisture year-round. Over time this mix opens caulk joints, lifts paint and lets water soak into the end grain of trim and deck boards.

Our crew comes out from our Woodinville office, and we also work in nearby Lynnwood, Mountlake Terrace, Shoreline and Mukilteo.

Warning signs

When to call about fascia and soffit repair in Edmonds

  • Birds, bees or rodents getting into the eaves
  • Water running behind the gutter
  • Peeling paint or soft spots on the fascia
  • Moss and debris building up at the roof edge
  • Holes or stains in the soffit
Our process

Our fascia and soffit repair process, step by step

1

Inspect the roof edge

We check fascia, soffit and rafter tails from a ladder and photograph damage.

2

Remove gutters if needed

Gutters come down carefully to reach the fascia.

3

Replace rotted wood

Fascia, soffit and rafter tails rebuilt to solid wood.

4

Add drip edge

Drip edge under the roofing so water clears the board.

5

Finish

Primed or painted and ready for gutters to go back up.

Our work

Recent fascia and soffit repair projects near Edmonds

See all projects →
Gable wall after siding repair
Side wall after re-siding
Eco Home Repair project

What we do in Edmonds

Soffits and vents

New soffit panels and vents so the attic can breathe.

Drip edge

Metal drip edge so water clears the fascia.

Fascia boards

Rotted fascia replaced with primed or rot-resistant boards.

Pest damage

Close up openings where animals got into the eaves.

Rafter tails

Rotted rafter ends sistered or rebuilt.

Gutter-ready

Solid backing ready for your gutter installer.

Local know-how

Neighborhoods and permits in Edmonds

In the Bowl, older homes near downtown have original wood, tight lots and porches that have weathered many decades of rain. Seaview and the hillside streets overlooking the ferry dock get the strongest wind and salt on their view sides. Perrinville and other neighborhoods along wooded creek ravines stay shaded and damp, letting moss and rot settle into roofs and lower walls. Five Corners and Westgate hold many 1960s and 70s homes now reaching the age when decks, trim and flashing all need attention.

Minor fixes such as replacing a few decayed boards or trim pieces with the same material often can proceed without a permit. Deck construction, structural repairs and bigger replacements usually need one, and the city may look more closely at work on steep slopes or near the shoreline. We verify the rules with the City of Edmonds and take care of the permit if one applies.

Compare

Fascia and soffit materials

MaterialRot resistanceUpkeepGood to know
Primed wood fasciaLow to mediumRepaint every 5–8 yearsMatches most older homes
Cedar fasciaMediumPaint or stain on scheduleHolds paint well, natural look
PVC or composite fasciaVery highOccasional washingGood choice where gutters overflow
Aluminum wrap over woodHighLittleProtects the board, but hides rot if wood was wet
Pricing

What fascia and soffit repair typically costs in Edmonds

ProjectTypical scopePrice rangeTimeline
Small sectionA few feet of fascia or one soffit panel$500 – $1,5001 day
One side of the houseFascia, soffit and drip edge along one roof edge$2,000 – $5,5001–2 days
Rafter-tail repairFascia plus rotted rafter ends sistered or rebuilt$3,500 – $9,0002–4 days
Whole houseRoof edge, soffits and venting all around$7,000 – $18,0001–2 weeks

These are typical 2026 ranges we see for fascia and soffit repair in Edmonds and nearby cities. Your price depends on what we find once the area is open, access and height, and the materials you choose. Every estimate is free, in writing and based on an on-site inspection with photos.

Guide

Fascia & soffit repair in Edmonds: cost and timing

Most common causes

Overflowing gutters

Clogged gutters spill water onto the fascia every storm.

Pests

Gaps in rotted soffits let birds, bees and rodents into the eaves.

Blocked soffit vents

Poor attic ventilation traps moisture at the roof edge.

What drives the price in Edmonds

Fascia and soffit repair in Edmonds is priced by the length of damaged roof edge, roof height, rafter-tail damage and gutter work. A few feet of fascia is a quick fix; a whole side of the house takes longer. You get a written price after the free inspection.

Typical timeline

Most roof-edge repairs are wrapped up in one to three days, a bit longer if the gutters come down or rafter tails need work.

Warranty

Backed by a 24-month workmanship warranty

Written scope

You know exactly what is included before work starts, with photos of what we found.

Our own crew

The people who quote your job are the people who do it, start to finish.

Clean site daily

Debris is hauled away and your yard is left the way we found it.

24 months covered

If our workmanship fails within two years, we come back and make it right.

Reviews

What homeowners near Edmonds say

“We're extremely pleased with the work Alex and the team completed on our home. They gave the entire exterior a fresh new look with new siding, renovated our front porch, and built an additional side porch and back deck. They also replaced several of our…”
CD
Casey D.
Google review · Sep 2026
“Alex does high quality work and his prices are very reasonable. I recommend him.”
AE
A. Edward M.
Google review · Jun 2026
“Very professional, quick to respond, and able to schedule the work on short notice they treated our home and deck with care and did an excellent job. I would definitely hire them again for a future project.”
JB
Jensen B.
Google review · Sep 2026

5.0 average from 106 reviews on Google, Thumbtack, Angi, HomeAdvisor and Yelp. Read our reviews on Google.

FAQ

Questions Edmonds homeowners ask about fascia and soffit repair

Can you match the original siding on an older home in the Bowl in Edmonds?
Usually, yes. We match lap, shingle and other cedar profiles board by board, and we can mill custom trim when stock pieces will not work. When the existing material is too far gone, we use the closest available profile and blend the repair with paint so it reads as original from the street.
Can you replace just part of the fascia in Edmonds?
Yes. We replace the rotted sections and scarf-join new boards so they look continuous once painted.
What is a drip edge?
A metal flashing at the roof edge that sends water into the gutter instead of behind it onto the fascia.
How long does fascia repair take?
Most fascia and soffit repairs take one to three days.
Can animals get in through damaged soffits?
Yes. We close the openings with new soffit and vents designed to keep pests out.
Free estimate

Tell us about your fascia and soffit repair project in Edmonds

  • Licensed, bonded & insured
  • Free on-site estimates
  • 24-month workmanship warranty

Tell us what needs repair

Tell us what you're seeing. We usually reply the same day.

Book a free fascia and soffit repair inspection in Edmonds

We inspect the damage on-site, show you photos of what we find and give you a written price before any work starts.

Get a Free Estimate